How to properly load WPSD or pi -star with the correct ssh command line
Go into WPSD
Advanced >>Tools>>SSH Access>> Then login with the following…”pi-star” use password “raspberry” … It will then load the WPSD ssh page … at the command line input the following… sudo wpsd-update os … do not forget the os at the end of the command line
What it will do is start loading your updates if needed but this is where the important part comes …just as it says it’s loading WPSD starting services it then states looking for any other software updates .. it takes some time looking .. Do not interrupt this command… it will then start unpacking a huge pack of needed files … this might take some time … wait till the end where you see the command libe in green writing .. exit out of it back to the main dashboard … you are then all set
If using pi-Star
Then using “sudo pistar-update os” with no spaces ..
looking for ssh section go into expert mode and look in the line below and access it
|
|||